Masonry contractor in French Valley, CA - block walls and repairs that blend in
Superior Perris Concrete and Masonry builds and repairs brick, block and stone work in French Valley, CA, from property walls and retaining walls to tuckpointing, veneer, walkways and outdoor kitchens on the homes here.
- Fully licensed and insured.
- Free on-site estimates.
- We reply within 1 business day.
French Valley homes, walls and yards as we see them
French Valley is mostly newer tract neighborhoods in unincorporated Riverside County, with stucco houses, concrete driveways and block walls running between nearly every pair of backyards. Most of the homes are lived in by the people who own them, and the calls we get here tend to come from owners fixing up a yard they plan to stay in: a new retaining wall, a stone front, a grill island or a property wall that's started to lean. It's the same kind of work we do in Murrieta and Menifee.
A lot of lots here sit on rolling ground, so backyards step down in terraces and the walls holding them carry real soil. That changes the job, because a wall on a slope needs a deeper or stepped footing and a way for water to get out from behind it.
Masonry services for French Valley homes
Foundation repair
When a slab corner cracks or a foundation wall shows a stair-step crack on a sloped lot, we find where the ground moved before we patch anything.
Chimney repair
A cracked crown, the concrete slab on top, or open joints let water into a chimney, so we rebuild those parts before the brick below starts to crumble.
Tuckpointing
When the mortar between bricks on a front planter or veneer wall turns sandy, we grind out the worn joints and pack in color-matched mortar.
Brick repair
A cracked or spalled brick, one with its face flaked off, can be cut out and swapped, so the wall keeps its look without a rebuild.
Driveway pavers
Many driveways here are plain gray concrete, and pavers over a packed base give a new look you can lift and reset if a section settles.
Retaining wall construction
Backyards that step down a slope need a wall that holds the soil, so we build block retaining walls with drainage behind them to let water out.
Masonry restoration
When brick or stone work has stains, washed-out joints and loose pieces, we clean it, refill the joints and reset what's loose so it fits the house again.
Fireplace installation
Indoors or out on the back patio, we build the firebox, chimney and hearth in brick or stone, sized to the room or yard it sits in.
Stone veneer installation
Thin stone veneer dresses up stucco fronts and column bases, and we set it over a proper backing so water that gets behind it can drain out.
Concrete block walls
Block walls line many lots here, and when one leans or cracks, we rebuild it on a footing sized for its height and the ground under it.
Foundation block wall installation
For an addition or garage on a sloped lot, we lay the block foundation wall with steel and grout in the cells so it carries the weight.
Outdoor kitchen masonry
A backyard grill island or bar wall gets used year after year, so we build it in block faced with stone, brick or stucco to match the house.
Walkway construction
A side-yard path or front walk in brick, pavers or stone gives firm footing from the gate to the door, on a packed base so it stays flat.
Brick wall installation
A brick garden wall, planter or entry wall adds warmth next to stucco, and we lay it on a real footing with joints tooled so they shed water.
Stone masonry
Natural stone suits columns, low walls and planters on the larger lots here, and we fit each stone by hand so the joints stay tight.
Brick pointing
If a few joints on a planter, step or wall have cracked out, we refill just those, matching color and joint shape so the fix blends in.
Get a free on-site estimate for your French Valley project
We reply within one business day to set a time, then I come out myself to look the job over and give you a written estimate. There's no obligation to go ahead.
- Based in
- Perris, CA 92571
- Hours
- Mon–Fri: 8 AM–10 PM, Sat–Sun: 7 AM–9 PM
What working in unincorporated French Valley means for your job
Because French Valley is unincorporated, building permits here come from the Riverside County Building & Safety Department, not a city hall, and you can reach it at (951) 955-1800. When a job needs a permit, we pull it and line up the inspections, and since the county's review usually sets the start date, we get the paperwork in early. If you'd rather pull it yourself as the owner, I'll go over what the office asks for. The thing to ask any contractor about is a state license, because the California Contractors State License Board requires one whenever a job needs a building permit, uses any additional workers, or adds up to $1,000 or more in labor and materials, counting every contract on the project. The county doesn't issue business licenses, so there's no local license to ask for, though businesses based in the unincorporated area register for the county's Stormwater Compliance Program. We're fully licensed and insured.
The price mostly follows the size of the job, how much digging and footing the ground calls for, whether an old wall has to come out first, and how easily we can get block and a mixer into your yard. The schedule turns on the permit review and, if your tract has an HOA, on its approval, so check its rules on wall height and finish before we price anything. I'll put your own figure in a written estimate once I've seen the job, and it's the same block and stone work we do in Temescal Valley and the other cities around Perris.
Hot, dry wind and sprinkler water on walls here
Every year this part of Riverside County gets hot, dry Santa Ana winds, and they pull water out of fresh mortar before it can cure, which leaves weak, crumbly joints. On windy days we keep new work damp and covered so it cures slowly, and on a tall freestanding wall we set steel and fill the cells with grout so it stands up to the push of the wind.
Block walls between neighbors take water from both yards' sprinklers, and soil that stays wet under a footing softens and lets the wall tip. We fix where the water's coming from along with the wall, because rebuilding without fixing the drainage just starts the clock over.
How a masonry job runs when you hire us in French Valley
From your first call to the walk-through at the end, here's how a masonry job goes with us in French Valley.
Call or send us a note
Call (951) 418-3037 or use the form, and we'll set a visit for a time that suits you. We answer into the evening and on weekends, so after work is fine.
I look the job over
I come out myself, walk the wall or yard with you and answer whatever you want to ask. Then I write up an estimate, so you have the price on paper before you decide anything.
We pull permits and build
If the job needs a permit, the work starts once the county has reviewed it and the inspections are lined up. I'm on the job with our crew, and you don't need to be home as long as we can get into the yard.
We walk it with you
When the work's done, we clean up and walk the finished job with you. You can look over every joint and ask about anything before we pack up.
Questions about masonry work in French Valley
Does a block wall or retaining wall need a permit in French Valley?
Often it does. The county's permit flyer lists retaining walls and fences over 6 feet in height among the work that needs a permit, while the county building ordinance exempts fences up to 7 feet high but not block walls over 4 feet. Since the two draw the line differently, give the department your wall's height before you count on an exemption.
Which building code applies to a new masonry permit in French Valley?
A permit application the county receives on or after January 1, 2026 has to follow the 2025 California Building Codes. Applications that were already complete before that date stay under the code in effect when they were filed, so a job you're starting now gets drawn up to the 2025 codes.
How much does a new block wall cost in French Valley?
The cost comes down to how long and tall the wall is and what it has to hold back, and I give you the number in a written estimate after I've seen the spot. A retaining wall or a wall on a slope needs a bigger or stepped footing and more steel than a short wall on flat ground, and a stone or stucco face, a decorative cap or tearing out an old wall each add to it. A plain block wall on level ground with easy access is the least costly way to go.
What causes white powder on block walls in French Valley yards?
That white powder is efflorescence, salt left behind when water soaks through block or mortar and dries on the face. In yards here it usually traces back to sprinklers hitting the wall or soil piled against it, so we fix the water first and then clean the face, because cleaning alone just lets it come back.
What is the best way to match a repair to the existing brick or block on my French Valley home?
The best way is to match three things: the brick or block, the mortar color and the shape of the joint, because a miss on any one of them makes a patch stand out. We take a piece or a photo to the supplier for the closest match, mix test batches until the dry mortar color lines up and tool the joints the way the old ones were done. New work can look a shade fresh at first and usually settles in as it weathers.
How do I know if a leaning block wall in French Valley needs to be rebuilt?
A wall that leans a little more each season, sits on a cracked or shifted footing, or has cracks running through the block itself usually needs to come down and go back up on a new footing. A hairline crack along a mortar joint on a wall that's still standing straight can often wait a while, and refilling the joint may be all it needs. I'll look at it with you and tell you which one you've got.
Ask about your French Valley wall today
Call (951) 418-3037 or send the form, and I'll tell you straight whether that crack or lean needs work now or can wait a while.